Dear Sir/Mdm,

I am doing a research that wishes to investigate the SVF of buildings. I have a small problem whereby the coordinates of the vector that I loaded into skyhelios would not show on the software. I have changed the coordinate system of the vector to UTM but it did not show out the coordinates. As I need to have the lat/log for my research, I would like to know how to go about with this problem. I have attached a picture of the issue in this message.

Thank you so much and I apologise for the inconvenience caused:)

Dear Marcel,

Thank you for your response and clarification. I am not too sure which version of Skyhelios I am using as it was passed to me from a colleague of mine. May I check where could I get the more updated version of Skyhelios?

Thank you and I apologise for the inconvenience caused.

Best Wishes
Rebecca